Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Neck thickness and clearance?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Edd" data-source="post: 1313560" data-attributes="member: 30592"><p>If I was neck turning the brass, I would leave it as thick as I could as long as it wasn't over .015" thick. I would want the chamber neck .004" larger than a loaded round. If I was having a reamer made I would have them taper the neck so there was .004" clearance at the front and .005' clearance at the rear.</p></blockquote><p></p>
[QUOTE="Edd, post: 1313560, member: 30592"] If I was neck turning the brass, I would leave it as thick as I could as long as it wasn't over .015" thick. I would want the chamber neck .004" larger than a loaded round. If I was having a reamer made I would have them taper the neck so there was .004" clearance at the front and .005' clearance at the rear. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Neck thickness and clearance?
Top