Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck clean-up, cutting depth?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="arthurj" data-source="post: 72853" data-attributes="member: 3718"><p>That is what I was wondering also. "Ideally" I would give each neck a 100% turn to achieve uniform thickness, but I was wondering if that would increase the clearance in the neck of the chamber too much. Being as this is a factory rifle I have no clue what size the neck of my chamber is. Can I measure the necks of fired cases to get a "guestimate?" I know lapua brass is thicker than most so could I go ahead and trim each neck to .0130?</p></blockquote><p></p>
[QUOTE="arthurj, post: 72853, member: 3718"] That is what I was wondering also. "Ideally" I would give each neck a 100% turn to achieve uniform thickness, but I was wondering if that would increase the clearance in the neck of the chamber too much. Being as this is a factory rifle I have no clue what size the neck of my chamber is. Can I measure the necks of fired cases to get a "guestimate?" I know lapua brass is thicker than most so could I go ahead and trim each neck to .0130? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck clean-up, cutting depth?
Top