Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
My reloading process.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="boomtube" data-source="post: 229315" data-attributes="member: 9215"><p>"My process certainly doesn't fix bad brass, but I believe it limits additional runout. If you have a better way to 'limit additional runout during the reloading process' please enlighten us."</p><p> </p><p>No enlightenment or correction is needed, you are aleady getting good results so I have no suggestions for you to change. My point is that I have found that rotatinga case after the bullet starts off axis rarely does anything to correct it. </p><p> </p><p>For sure, no good comes from a rapid lever action! I just use a clean, smooth stroke and find maybe 80% of my ammo has a run-out/tilt of less than a thou IF the cases and dies are good. I cull those cases with run-out over one thou and after awhile it's ALL good!</p><p></p><p>"As far as the electronic powder dispensing system adding or subtracting, you are probably right. I do believe it is accurate enough for anything I am doing."</p><p> </p><p>Again, not a challange, accuracy of dispensing wasn't my point. It was just an observation for others that while a digital powder system is simpler and may even be faster, it is expensive and adds no accuracy to the the final product. IF the loader uses good technique, anyway! </p><p> </p><p>Sloppy loaders can't seem to produce good ammo on any tools but good loaders will find out what's wrong and make their ammo good! <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile :)" loading="lazy" data-shortname=":)" /></p></blockquote><p></p>
[QUOTE="boomtube, post: 229315, member: 9215"] "My process certainly doesn't fix bad brass, but I believe it limits additional runout. If you have a better way to 'limit additional runout during the reloading process' please enlighten us." No enlightenment or correction is needed, you are aleady getting good results so I have no suggestions for you to change. My point is that I have found that rotatinga case after the bullet starts off axis rarely does anything to correct it. For sure, no good comes from a rapid lever action! I just use a clean, smooth stroke and find maybe 80% of my ammo has a run-out/tilt of less than a thou IF the cases and dies are good. I cull those cases with run-out over one thou and after awhile it's ALL good! "As far as the electronic powder dispensing system adding or subtracting, you are probably right. I do believe it is accurate enough for anything I am doing." Again, not a challange, accuracy of dispensing wasn't my point. It was just an observation for others that while a digital powder system is simpler and may even be faster, it is expensive and adds no accuracy to the the final product. IF the loader uses good technique, anyway! Sloppy loaders can't seem to produce good ammo on any tools but good loaders will find out what's wrong and make their ammo good! :) [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
My reloading process.
Top