Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
MPI shifts.....I have a problem!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Pete Lincoln" data-source="post: 77951" data-attributes="member: 2245"><p>Was the modeartor tight? is it threaded square to the axis of the bore? if you didn't vave the mod on, was the thread cap tight? </p><p>Are you still using them crappy AI mounts? </p><p>are the mounts tight, are they slipping on either the scope or the base? if your scope isn't glued in with acraglass or something like that i ca gaurantee you will get some time of other sooner or later slipping scope in rings if you are still using that AI mount. </p><p>Finaly, clamp the rifle and check the scope is tracking, i doubt that the S&amp;B PMII is causing problems but your adjustment BDC clamping screws might be letting the BDG slip, i had that when i didnt to tighten both screws properly during zeroing and then forgot there after , every time i wound back to zero, i was nudging the BDC past the 0 and gradualy ending up with elevated POI. </p><p>cheers Pete</p></blockquote><p></p>
[QUOTE="Pete Lincoln, post: 77951, member: 2245"] Was the modeartor tight? is it threaded square to the axis of the bore? if you didn't vave the mod on, was the thread cap tight? Are you still using them crappy AI mounts? are the mounts tight, are they slipping on either the scope or the base? if your scope isn't glued in with acraglass or something like that i ca gaurantee you will get some time of other sooner or later slipping scope in rings if you are still using that AI mount. Finaly, clamp the rifle and check the scope is tracking, i doubt that the S&B PMII is causing problems but your adjustment BDC clamping screws might be letting the BDG slip, i had that when i didnt to tighten both screws properly during zeroing and then forgot there after , every time i wound back to zero, i was nudging the BDC past the 0 and gradualy ending up with elevated POI. cheers Pete [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
MPI shifts.....I have a problem!!
Top