Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
Looking for a 6.5 cartridge
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="drocks101" data-source="post: 989568" data-attributes="member: 43990"><p>What I read was that most Laupa brass is around .296 neck diameter, so I was thinking that if I neck turned down the .293 it would be just enough to shave a little bit off of each piece of brass even if some piece had a smaller neck diameter but it would not take off too much brass. I could then used a .290 die to get my neck tension.</p></blockquote><p></p>
[QUOTE="drocks101, post: 989568, member: 43990"] What I read was that most Laupa brass is around .296 neck diameter, so I was thinking that if I neck turned down the .293 it would be just enough to shave a little bit off of each piece of brass even if some piece had a smaller neck diameter but it would not take off too much brass. I could then used a .290 die to get my neck tension. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
Looking for a 6.5 cartridge
Top