Longest surface bearing .308 Caliber 180 grain bullet

Discussion in 'Rifles, Bullets, Barrels & Ballistics' started by trout-n-salmon, Mar 11, 2011.

  1. trout-n-salmon

    trout-n-salmon Well-Known Member

    Messages:
    136
    Joined:
    Nov 23, 2009
    Does anyone know the surface bearing lengths of the Accubond, Scirocco Swift II and Interbond in a .308 180 grain bullet?

    I am curious to see the differences in the bullets and this is just a hunch, but figure since they are all about the same length overall, if I shoot the one with the longest surface bearing, I technically should be able to get the ogive closer to the lands so I am not jumping the bullet as far. I am limited by the COAL due to by magazine length.

    Does this make sense?