Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Load testing with new brass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Bart B" data-source="post: 672131" data-attributes="member: 5302"><p>As I've sometimes done, yes, you misunderstood. Welcome to the club.</p><p></p><p>I've never heard of changing seating depth to change muzzle velocity such that bullets exit at different muzzle angles.</p><p></p><p>But the ideal place for bullets to leave in the barrel's vertical whip cycle is just before the bore axis at the muzzle's risen to its greatest angle. Slower bullets typcally have a bit longer barrel time than faster ones so they'll leave later when the muzzle axis angle's a bit higher compensating for their greater drop. Faster ones leave sooner and at lower angles. I don't know if anybody's measured this in recent years using accelerometers on the barrel connected to test equipment that shows where the bore axis points when the bullet leaves. There's been calculations made based on accepted facts of metalurgy behaviour and vibration analysis. And theories abound all over this planet about this subject which have never been verified by actual measurements.</p></blockquote><p></p>
[QUOTE="Bart B, post: 672131, member: 5302"] As I've sometimes done, yes, you misunderstood. Welcome to the club. I've never heard of changing seating depth to change muzzle velocity such that bullets exit at different muzzle angles. But the ideal place for bullets to leave in the barrel's vertical whip cycle is just before the bore axis at the muzzle's risen to its greatest angle. Slower bullets typcally have a bit longer barrel time than faster ones so they'll leave later when the muzzle axis angle's a bit higher compensating for their greater drop. Faster ones leave sooner and at lower angles. I don't know if anybody's measured this in recent years using accelerometers on the barrel connected to test equipment that shows where the bore axis points when the bullet leaves. There's been calculations made based on accepted facts of metalurgy behaviour and vibration analysis. And theories abound all over this planet about this subject which have never been verified by actual measurements. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Load testing with new brass
Top