Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Lee collet die - no -neck - tension-WHY ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ol mike" data-source="post: 104971" data-attributes="member: 4683"><p>Pulled the die apart and it measured too close to .224 after a high speed drill - fine steel wool and fritz spin job it cleaned up nice.</p><p></p><p>The press isn't going to cut the mustard though.It's hard to believe this [pot metal] cast aluminum linkage is suppose to hold up w/the force needed for the collet die.</p><p>I'm going to check-out the co-ax press.Thanks Mike</p></blockquote><p></p>
[QUOTE="ol mike, post: 104971, member: 4683"] Pulled the die apart and it measured too close to .224 after a high speed drill - fine steel wool and fritz spin job it cleaned up nice. The press isn't going to cut the mustard though.It's hard to believe this [pot metal] cast aluminum linkage is suppose to hold up w/the force needed for the collet die. I'm going to check-out the co-ax press.Thanks Mike [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Lee collet die - no -neck - tension-WHY ?
Top