Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
The Basics, Starting Out
Just getting into LRH and looking for advice on my rig..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Hookturnr" data-source="post: 420789" data-attributes="member: 22612"><p>My brass prep is as follows: FL resize, trim to spec. deburr and chamfer neck, clean/uniform primer pocket, sort by weight and load. </p><p> </p><p>I haven't gotten into neck turning yet... </p><p> </p><p> I'm using either nosler custom brass or remington brass with the loads adjusted accordingly..usually about .6 gr lighter charge in the nosler.........</p><p>The nosler brass seems to be great stuff. Extremely uniform throughout a lot and nice fit / finish. Hopefully it holds up as well or better than the rem. brass.</p><p> </p><p>I've been quite happy with my results in a couple other guns. My encore PH in 25/06 will shoot .4" 5 shot groups in nice little round holes all day long with my handload for it. </p><p> </p><p>My concern with my 300 load is I don't seem to be getting the nice round or square group, instead its a line through the bull. my vertical in the group is almost dead even shot to shot and the group opens up to 5/8-7/8 horizontally.</p><p> </p><p>I probably shouldn't be complaining about flirting with 1/2MOA with a factory tube on there n it may just be me, my technique, my trigger pull....I just have a taste for cutting one ragged hole and most my guns do it.</p></blockquote><p></p>
[QUOTE="Hookturnr, post: 420789, member: 22612"] My brass prep is as follows: FL resize, trim to spec. deburr and chamfer neck, clean/uniform primer pocket, sort by weight and load. I haven't gotten into neck turning yet... I'm using either nosler custom brass or remington brass with the loads adjusted accordingly..usually about .6 gr lighter charge in the nosler......... The nosler brass seems to be great stuff. Extremely uniform throughout a lot and nice fit / finish. Hopefully it holds up as well or better than the rem. brass. I've been quite happy with my results in a couple other guns. My encore PH in 25/06 will shoot .4" 5 shot groups in nice little round holes all day long with my handload for it. My concern with my 300 load is I don't seem to be getting the nice round or square group, instead its a line through the bull. my vertical in the group is almost dead even shot to shot and the group opens up to 5/8-7/8 horizontally. I probably shouldn't be complaining about flirting with 1/2MOA with a factory tube on there n it may just be me, my technique, my trigger pull....I just have a taste for cutting one ragged hole and most my guns do it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
The Basics, Starting Out
Just getting into LRH and looking for advice on my rig..
Top