Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Issue with forming AI brass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="codyadams" data-source="post: 1330389" data-attributes="member: 87243"><p>If the chamber was formed right, there is no need to jam the bullets. Proper ai chambers have a crush fit on the parent case. But if the chamber isnt formed right they need to be seated out. </p><p></p><p>And I agree, when forming for my .260 AI I used starting loads for a standard .260. There is literally no need at all to load them hot, the pressure is not necessary and it just over works your brass. You can fireform using the COW method, you don't need 65,000 psi to get brass formed. I actually split necks when I started with a max .260 load forming to .260 AI.</p></blockquote><p></p>
[QUOTE="codyadams, post: 1330389, member: 87243"] If the chamber was formed right, there is no need to jam the bullets. Proper ai chambers have a crush fit on the parent case. But if the chamber isnt formed right they need to be seated out. And I agree, when forming for my .260 AI I used starting loads for a standard .260. There is literally no need at all to load them hot, the pressure is not necessary and it just over works your brass. You can fireform using the COW method, you don't need 65,000 psi to get brass formed. I actually split necks when I started with a max .260 load forming to .260 AI. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Issue with forming AI brass
Top