Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Is it possible for the bore and the chamber to be non-concentric ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="brian11" data-source="post: 2896337" data-attributes="member: 112031"><p>It is absolutely possible. In fact, it's "probable", unless steps are taken to eliminate it. Most (and all custom) chambers are cut on different machines, at different times, by different people, than the boring and rifling operations. When the chamber is cut, it's a simple and routine matter to make sure the barrel is mounted in the lathe concentric to the bore. If this step is not taken, or taken in haste or done poorly, then your chamber is not going to be concentric with the bore.</p></blockquote><p></p>
[QUOTE="brian11, post: 2896337, member: 112031"] It is absolutely possible. In fact, it's "probable", unless steps are taken to eliminate it. Most (and all custom) chambers are cut on different machines, at different times, by different people, than the boring and rifling operations. When the chamber is cut, it's a simple and routine matter to make sure the barrel is mounted in the lathe concentric to the bore. If this step is not taken, or taken in haste or done poorly, then your chamber is not going to be concentric with the bore. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Is it possible for the bore and the chamber to be non-concentric ?
Top