Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Is it possible for the bore and the chamber to be non-concentric ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="stiff neck" data-source="post: 2896049" data-attributes="member: 13175"><p>First clue was my bullets were engaging the lands unevenly. BHW said it was probably just a sharp edge on one side of the lands or a burr that would even out once it was broken in. But I was also getting pressure signs with moderate loads. That may have been caused by the short throat forcing me to seat bullets super deep and most loads were compressed. Accuracy was also terrible. BHW diagnosed the non-concentric bores and they eventually figured out that PT&G had incorrectly re-ground their reamer which they used on both of my barrels resulting in the short throat.</p></blockquote><p></p>
[QUOTE="stiff neck, post: 2896049, member: 13175"] First clue was my bullets were engaging the lands unevenly. BHW said it was probably just a sharp edge on one side of the lands or a burr that would even out once it was broken in. But I was also getting pressure signs with moderate loads. That may have been caused by the short throat forcing me to seat bullets super deep and most loads were compressed. Accuracy was also terrible. BHW diagnosed the non-concentric bores and they eventually figured out that PT&G had incorrectly re-ground their reamer which they used on both of my barrels resulting in the short throat. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Is it possible for the bore and the chamber to be non-concentric ?
Top