Inletting a Hogue

Discussion in 'Gunsmithing' started by goatsie, Jul 7, 2012.

  1. goatsie

    goatsie Well-Known Member

    Messages:
    186
    Joined:
    Jan 17, 2009
    I have s seekins DBM I wanna slap on a hogue SA overmold stock until I save up for a manners. Has anyone ever inletted one? Bad idea?
     
  2. Dr. Vette

    Dr. Vette Well-Known Member

    Messages:
    2,033
    Joined:
    Dec 30, 2009
    This would be the correct answer. :D
     

  3. goatsie

    goatsie Well-Known Member

    Messages:
    186
    Joined:
    Jan 17, 2009
    Yeah I figured as much, but just wanted to check if it was possible, but I think in this case, possible and foolish are one in the same!
     
  4. Daveinjax

    Daveinjax Well-Known Member

    Messages:
    504
    Joined:
    May 21, 2012
    I tried to do some work on one I had and it turned into a mess. The soft rubber on the edge was hard to cut strait. It deforms as you cut and when you pull away the strait line you just cut isn't strait. No way to fix little nicks in the rubber.