Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
IMR4350 vs. H4350
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="lloydsmale" data-source="post: 629920" data-attributes="member: 41442"><p>well jack all i can post is facts that came from actualy chonographing my loads running powders to the point that pressure signs start developing then backing off a bit. In my experience the 257 is a bit overbore for powders as fast as 4350. Also id look at the pressure that manual gives for that 4350 load then compare it to the pressure for the 4831 load and id bet there loading 4350 to a higher pressure to beat powders like 4831, 7828, re25 ect. Run those powders to the same pressure and see what you get.</p></blockquote><p></p>
[QUOTE="lloydsmale, post: 629920, member: 41442"] well jack all i can post is facts that came from actualy chonographing my loads running powders to the point that pressure signs start developing then backing off a bit. In my experience the 257 is a bit overbore for powders as fast as 4350. Also id look at the pressure that manual gives for that 4350 load then compare it to the pressure for the 4831 load and id bet there loading 4350 to a higher pressure to beat powders like 4831, 7828, re25 ect. Run those powders to the same pressure and see what you get. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
IMR4350 vs. H4350
Top