Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
HS recoil pad removal
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="learning" data-source="post: 339006" data-attributes="member: 17382"><p>Put your stock in the freezer for three hours. Then put the recoil pad and little plastic piece attached to the recoil pad in a vice. Then just pull it apart, your pad will need to be replaced when you get it off becase the plastic piece on the pad will break when you tighten the vice. There is a hole about seven inches deep by 1 7/8 inches wide by 3 inches tall. You will have plenty of stock back there to screw your new l o p thing to.</p></blockquote><p></p>
[QUOTE="learning, post: 339006, member: 17382"] Put your stock in the freezer for three hours. Then put the recoil pad and little plastic piece attached to the recoil pad in a vice. Then just pull it apart, your pad will need to be replaced when you get it off becase the plastic piece on the pad will break when you tighten the vice. There is a hole about seven inches deep by 1 7/8 inches wide by 3 inches tall. You will have plenty of stock back there to screw your new l o p thing to. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
HS recoil pad removal
Top