Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hornady 338 lapua brass neck thickness.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rosseickhoff" data-source="post: 2726297" data-attributes="member: 37551"><p>Some of the cases wouldn't hold a bullets tight after they were sized and then started seating bullets. The ones that did I could pull them out by hand. </p><p>All I have right now is a digital micrometer to measure with. The brass seems that it is in spec so now I believe that my Redding sizing die has an issue. </p><p>The bushing wasn't making contact with the necks as I pulled it out. The die set was used and I'm not sure what is going on with it. I ordered a new sizing die to see if this was the problem. I suspected initially it was the brass but they seem to be in spec so I'm thinking the sizing die is either worn out, I don't actually know if they wear out, or was modified for some reason before I got them. </p><p>It's a Redding benchrest set with the micrometer seater.</p></blockquote><p></p>
[QUOTE="rosseickhoff, post: 2726297, member: 37551"] Some of the cases wouldn’t hold a bullets tight after they were sized and then started seating bullets. The ones that did I could pull them out by hand. All I have right now is a digital micrometer to measure with. The brass seems that it is in spec so now I believe that my Redding sizing die has an issue. The bushing wasn’t making contact with the necks as I pulled it out. The die set was used and I’m not sure what is going on with it. I ordered a new sizing die to see if this was the problem. I suspected initially it was the brass but they seem to be in spec so I’m thinking the sizing die is either worn out, I don’t actually know if they wear out, or was modified for some reason before I got them. It’s a Redding benchrest set with the micrometer seater. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hornady 338 lapua brass neck thickness.
Top