Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Help a gal with load development-seating depth
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="codyadams" data-source="post: 1743439" data-attributes="member: 87243"><p>I do the same thing, start between .005" and .010" off, and go in .030" increments. Once you have the best one, finish out your powder charge and primer choices, then fine tune your depth by going up and down in .005" increments, until I find the best one. You can fine tune from there in .001" increments, but I have always had good enough accuracy that it wasn't necessary.</p></blockquote><p></p>
[QUOTE="codyadams, post: 1743439, member: 87243"] I do the same thing, start between .005" and .010" off, and go in .030" increments. Once you have the best one, finish out your powder charge and primer choices, then fine tune your depth by going up and down in .005" increments, until I find the best one. You can fine tune from there in .001" increments, but I have always had good enough accuracy that it wasn't necessary. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Help a gal with load development-seating depth
Top