Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Hard/impossible extraction Rem 700
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="243winxb" data-source="post: 1898285" data-attributes="member: 97793"><p>Photo of brass-Necks. Looks like a bushing die was used.</p><p></p><p>I would want to know chambers neck diameter & loaded rounds outside neck diameter. Is there enough clearance? Minimum of .003"</p><p>Or compare a loaded rounds OD to fired brass OD.</p><p></p><p>Did brass start life as a 7mm, then necked down. Has a donut formed after a few loadings.</p><p></p><p>Trim length checked & compared to chamber length.</p></blockquote><p></p>
[QUOTE="243winxb, post: 1898285, member: 97793"] Photo of brass-Necks. Looks like a bushing die was used. I would want to know chambers neck diameter & loaded rounds outside neck diameter. Is there enough clearance? Minimum of .003" Or compare a loaded rounds OD to fired brass OD. Did brass start life as a 7mm, then necked down. Has a donut formed after a few loadings. Trim length checked & compared to chamber length. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Hard/impossible extraction Rem 700
Top