Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hard bolt Lift
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="martyj" data-source="post: 2720741" data-attributes="member: 24967"><p>Steps for making brass see if I'm missing something.</p><p>1 run it through neck sizing die with .330 bushing than do it a second time for .308 to get it down to .280 ID</p><p> 2 trim case to length</p><p>3turn neck with neck turning and 23 degree bit up to the shoulder</p><p>4 load shoot and all is fine till second reloading that's when bolt lift is tight and accuracy is still good.</p><p> Going to start reaming ID of case neck to make sure there isnt a doughnut issue.</p></blockquote><p></p>
[QUOTE="martyj, post: 2720741, member: 24967"] Steps for making brass see if I'm missing something. 1 run it through neck sizing die with .330 bushing than do it a second time for .308 to get it down to .280 ID 2 trim case to length 3turn neck with neck turning and 23 degree bit up to the shoulder 4 load shoot and all is fine till second reloading that's when bolt lift is tight and accuracy is still good. Going to start reaming ID of case neck to make sure there isnt a doughnut issue. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hard bolt Lift
Top