Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Half of case stuck in chamber, any advice?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Dgd6mm" data-source="post: 1077218" data-attributes="member: 12044"><p>Just for fun, if it was me, I would inspect them with a paperclip that is straightened out with a short 90 degree turn one one end. Run it inside down to the base of the case and slowly drag the end against the case up towards the mouth about halfway. Do this around the entire 36 degrees of the case. If a separation is starting you will fell the change, like a snag in the wall. I know they make tools for doing this, but this is the easiest way without the tool.</p></blockquote><p></p>
[QUOTE="Dgd6mm, post: 1077218, member: 12044"] Just for fun, if it was me, I would inspect them with a paperclip that is straightened out with a short 90 degree turn one one end. Run it inside down to the base of the case and slowly drag the end against the case up towards the mouth about halfway. Do this around the entire 36 degrees of the case. If a separation is starting you will fell the change, like a snag in the wall. I know they make tools for doing this, but this is the easiest way without the tool. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Half of case stuck in chamber, any advice?
Top