Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Good gunsmith
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="mulie" data-source="post: 2279486" data-attributes="member: 19271"><p>Well not sure if you actually needed a new reciever? Again you could silver solder (not weld) to fill in then machine new holes to align scope with center of receiver raceway if needed. Besides depending on what PacNor did to fit your barrel? Did they do any blue printing to the receiver did the go with original receiver threads? Tenon threads on the new barrel were they pretty much STD for that Mauser action. The new action you just got is it a Mauser action from the same production country? One would have to measure the current new PacNor barrel tenton threads to see if it will be possible to fit the new receiver. Again should be a bit cheaper to align the scope base holes in the current reciever.</p></blockquote><p></p>
[QUOTE="mulie, post: 2279486, member: 19271"] Well not sure if you actually needed a new reciever? Again you could silver solder (not weld) to fill in then machine new holes to align scope with center of receiver raceway if needed. Besides depending on what PacNor did to fit your barrel? Did they do any blue printing to the receiver did the go with original receiver threads? Tenon threads on the new barrel were they pretty much STD for that Mauser action. The new action you just got is it a Mauser action from the same production country? One would have to measure the current new PacNor barrel tenton threads to see if it will be possible to fit the new receiver. Again should be a bit cheaper to align the scope base holes in the current reciever. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Good gunsmith
Top