Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Go NoGo Gauge Clarity
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mram10us" data-source="post: 1837058" data-attributes="member: 111667"><p>In the past year I started doing a lot of research about how to make my own headspace gauges. Read on the forums that they differ based on manufacturer. Called around and talk to numerous manufacturers stating the Go gauge is always tied to the minimum saami spec headspace shown in the picture below. NoGo gauges are not tied to a specific value and vary depending on cartridge and manufacturer. These are generally Go +.004-006", but again, no set value.</p><p>[ATTACH=full]176998[/ATTACH]</p><p>I bring this up because I caused some confusion the other day in the thread where JE Custom was mentioning head spacing zero-.0015" off of min spec. I asked if he went off the saami min spec or the go gauge itself. I shouldn't have said that because they are both one in the same with every manufacturer that I've talk to you. Again, the NoGo changes, but the Go is always associated with the min spec on the saami sheet. Sorry for any confusion I caused.</p></blockquote><p></p>
[QUOTE="Mram10us, post: 1837058, member: 111667"] In the past year I started doing a lot of research about how to make my own headspace gauges. Read on the forums that they differ based on manufacturer. Called around and talk to numerous manufacturers stating the Go gauge is always tied to the minimum saami spec headspace shown in the picture below. NoGo gauges are not tied to a specific value and vary depending on cartridge and manufacturer. These are generally Go +.004-006”, but again, no set value. [ATTACH type="full" alt="CF6F95E9-E215-4B31-B2A0-D688B51AC4D4.jpeg"]176998[/ATTACH] I bring this up because I caused some confusion the other day in the thread where JE Custom was mentioning head spacing zero-.0015” off of min spec. I asked if he went off the saami min spec or the go gauge itself. I shouldn’t have said that because they are both one in the same with every manufacturer that I’ve talk to you. Again, the NoGo changes, but the Go is always associated with the min spec on the saami sheet. Sorry for any confusion I caused. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Go NoGo Gauge Clarity
Top