Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Go/No Go Gauge Mystery
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DJ Fergus" data-source="post: 2198185" data-attributes="member: 93895"><p>I had a 25-06 rem 700. From the factory, chamber was .010" over no go. Factory chambers can be big and sloppy. I would bet on the no-go gauge being closer to accurate than the 700 chamber, and I usually don't take up for PTG. If you reload, just make sure that you only bump the shoulder back a few thousandths instead of maximum shoulder set back that the die will do.</p></blockquote><p></p>
[QUOTE="DJ Fergus, post: 2198185, member: 93895"] I had a 25-06 rem 700. From the factory, chamber was .010" over no go. Factory chambers can be big and sloppy. I would bet on the no-go gauge being closer to accurate than the 700 chamber, and I usually don't take up for PTG. If you reload, just make sure that you only bump the shoulder back a few thousandths instead of maximum shoulder set back that the die will do. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Go/No Go Gauge Mystery
Top