Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Full Length vs Neck Sizing!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TexSavage" data-source="post: 1763884" data-attributes="member: 6245"><p>Been FL bumping shoulders back .002 on my 300WSM for almost 10 years. Used WW nickel plated brass mainly, plus some WW brass brass. I have 10 to 12 reloads on them and have yet to have a case fail. I have started culling out and going to all Norma/Nosler due to it being the lowest ES of any brass I tried. Think I have about 1200 plus down the tube. I anneal after every other firing and trim as needed. Never have had any issue chambering rounds.</p></blockquote><p></p>
[QUOTE="TexSavage, post: 1763884, member: 6245"] Been FL bumping shoulders back .002 on my 300WSM for almost 10 years. Used WW nickel plated brass mainly, plus some WW brass brass. I have 10 to 12 reloads on them and have yet to have a case fail. I have started culling out and going to all Norma/Nosler due to it being the lowest ES of any brass I tried. Think I have about 1200 plus down the tube. I anneal after every other firing and trim as needed. Never have had any issue chambering rounds. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Full Length vs Neck Sizing!
Top