Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Full length size
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MNbogboy" data-source="post: 1457545" data-attributes="member: 18849"><p>Have had some dies that would not completely size brass from chambers that were headspace "snug" on the go gauge. Cure was to remove a couple thousandth off the top of the shell holder. You can also remove material from the bottom of the die.</p><p>BTW , I purchased my press from Herters about 50 years ago (Yes it's getting a little sloppy after a quarter of a million strokes)! But it still does the job.</p><p>Randy</p></blockquote><p></p>
[QUOTE="MNbogboy, post: 1457545, member: 18849"] Have had some dies that would not completely size brass from chambers that were headspace "snug" on the go gauge. Cure was to remove a couple thousandth off the top of the shell holder. You can also remove material from the bottom of the die. BTW , I purchased my press from Herters about 50 years ago (Yes it's getting a little sloppy after a quarter of a million strokes)! But it still does the job. Randy [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Full length size
Top