FS: Customized Remington 700 Sendero Stainless Fluted in 7STW Will consider trade for a NIB Swarovski 8x32 EL -Action trued and barrel cryo'd by Arnold Arms -Holland/McMillan Signature Series ADL stock bedded in Marine-tex with Hollands special screws -Holland muzzle brake -Holland recoil lug -Jewell trigger set at 1# -Badger Bolt knob -Holland "Bullet Proof" scope mounts -Barrel Tuff-Coated in matte black (wearing thin is some spots) Includes: Redding "S" neck die with .308" bushing as well as a Redding Deluxe die set with shellholder. 183 pcs of new Winchester brass and approximatly 55 pcs 1x & 2x fired brass. On a face to face sale, I will also throw in 3 lbs of Retumbo Rifle started out as a stock Sendero when the 7STW was introduced in 1996. Had Arnold Arms do their "accurizing oackage" on it. Then I added the stock upgrade and had Darrell Holland put a brake on it and his recoil lug. Barrel was set back when he added the lug at approx 300 rds. Barrel has about 600 through it now. Rifling and throat show no visible signs of wear. This rifle shoots 120gr Nosler BT's very well with my best groups in the low 2's. It also likes Nosler 160 Accubonds and more recently I have been shooting the Berger 168 VLD's and found a load that will push these into small groups while doing 3200fps with Retumbo. Rifle weighs 10 1/4 pounds with scope. Scope not included (Leupold 3.5-10x40 w/ele turret) but will sell for $400 with the rifle. Asking $1500 shipped to an FFL lower 48, California OK. An "I'll take it" here trumps a PM.