Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
forming 6.5x284 brass?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="crittrgittr" data-source="post: 772828" data-attributes="member: 33243"><p>I'm sure this has been discussed before, but I'm wondering about forming .284 brass to 6.5x284. I know it is probably better to buy Lapua brass, but I'm looking to go a little cheaper for now. I think in a previos forum someone said it was fine to take .284 brass and run it through the 6.5x284 sizing die. Any and all comments appreciated. Also, how much brass would be expected to be trimmed after sizing?</p></blockquote><p></p>
[QUOTE="crittrgittr, post: 772828, member: 33243"] I'm sure this has been discussed before, but I'm wondering about forming .284 brass to 6.5x284. I know it is probably better to buy Lapua brass, but I'm looking to go a little cheaper for now. I think in a previos forum someone said it was fine to take .284 brass and run it through the 6.5x284 sizing die. Any and all comments appreciated. Also, how much brass would be expected to be trimmed after sizing? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
forming 6.5x284 brass?
Top