7mmSendaro
Well-Known Member
Any advice on who to send my Encore to for a trigger job?
Encore Trigger job?
- Thread starter 7mmSendaro
- Start date
Help Support Long Range Hunting Forum
Ernie
SPONSOR
Mike Bellm
7mmSendaro
Well-Known Member
Thanks Ernie, I just found his site and ordered the kit!
I am beginning to see how you guys get addicted to this pistol thing! Even popping tiny groups at 100 yards with a .44 mag is a lot of fun. Can't even imagine shooting a full tilt hand gun as far as you do!
Ernie
SPONSOR
You have stepped to the "Dark Side" now 
It just gets better now
It just gets better now
Ream that .44 mag to .444 Marlin like I did and the fun really begins!
I would suggest changing the springs supplied in the Bellm kit and reassembling to check prior to any honing. When I put mine back together it was about 12 oz. pull. No over travel and the hammer won't push off; but I wasn't going for that low.
I would suggest changing the springs supplied in the Bellm kit and reassembling to check prior to any honing. When I put mine back together it was about 12 oz. pull. No over travel and the hammer won't push off; but I wasn't going for that low.
