Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
ejector marks even on light loads, any ideas
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="climb-101" data-source="post: 1065426" data-attributes="member: 31921"><p>measuring the case is one thing the gunsmith here told me to do also. I have the mic sitting with the shells so k can check them before and after to see what there doing. I measured some of the fired ones vs some vergin brass and I couldn't see any differance but that was just with my caliper so I'm guessing if it did move at all it's less than .0005". </p><p></p><p>as far as the manual, I have the sierra manual. not sure on the year but I'm guessing it's about 5 years old. I think the bottom load in it for H1000 was 82.5 grains and the top load was 92 grains. I was going to load up a few rounds tonight from 80-82 in half grain increments and to the SAMMI specs for the length and see what the brass looks likes as well as what the crono says. hopefully this weekend I can get out to test them if the weather holds up</p></blockquote><p></p>
[QUOTE="climb-101, post: 1065426, member: 31921"] measuring the case is one thing the gunsmith here told me to do also. I have the mic sitting with the shells so k can check them before and after to see what there doing. I measured some of the fired ones vs some vergin brass and I couldn't see any differance but that was just with my caliper so I'm guessing if it did move at all it's less than .0005". as far as the manual, I have the sierra manual. not sure on the year but I'm guessing it's about 5 years old. I think the bottom load in it for H1000 was 82.5 grains and the top load was 92 grains. I was going to load up a few rounds tonight from 80-82 in half grain increments and to the SAMMI specs for the length and see what the brass looks likes as well as what the crono says. hopefully this weekend I can get out to test them if the weather holds up [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
ejector marks even on light loads, any ideas
Top