Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
do you need to start over with load after neck turning?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BountyHunter" data-source="post: 2071104" data-attributes="member: 12"><p>do not make work for yourself. Unless your brass is showing a wide .003 variance I would not do it. If you want to, all you need to do is clean up the brass a little off the high spots for a stock chamber normally less than .001. If you have a stock chamber, then .012-.013 IMO is too thin, especially for hunting rifles. Erick Cortina is talking his match guns also, not hunting rifles.</p><p></p><p>After you turn them, load and fire them and then re-turn them to the same setting. You will find high spots have come out.</p><p></p><p>Now you know you are going to have to use bushing dies after turning also if you turn them a lot.</p><p></p><p>Jim Carstenson at JLC Precision can convert your dies to bushing. Last I knew it was $80 and couple weeks.</p></blockquote><p></p>
[QUOTE="BountyHunter, post: 2071104, member: 12"] do not make work for yourself. Unless your brass is showing a wide .003 variance I would not do it. If you want to, all you need to do is clean up the brass a little off the high spots for a stock chamber normally less than .001. If you have a stock chamber, then .012-.013 IMO is too thin, especially for hunting rifles. Erick Cortina is talking his match guns also, not hunting rifles. After you turn them, load and fire them and then re-turn them to the same setting. You will find high spots have come out. Now you know you are going to have to use bushing dies after turning also if you turn them a lot. Jim Carstenson at JLC Precision can convert your dies to bushing. Last I knew it was $80 and couple weeks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
do you need to start over with load after neck turning?
Top