Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Do I need to turn necks again?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Deleted member 107666" data-source="post: 1700011"><p>According to the RCBS precision mic...the shoulders didnt bump back at all. From zero on the gauge, new the brass was .012 (reads .037) under the zero line (min saami), after first firing they expanded out .006-.007 inches and guage (now reads .043). The Redding body sizing die in my forster Co-Ax did not bump the shoulder from that .043 reading</p></blockquote><p></p>
[QUOTE="Deleted member 107666, post: 1700011"] According to the RCBS precision mic...the shoulders didnt bump back at all. From zero on the gauge, new the brass was .012 (reads .037) under the zero line (min saami), after first firing they expanded out .006-.007 inches and guage (now reads .043). The Redding body sizing die in my forster Co-Ax did not bump the shoulder from that .043 reading [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Do I need to turn necks again?
Top