Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Dies not sizing enough?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dbhostler" data-source="post: 66602" data-attributes="member: 799"><p>You shouldn't have to have any component machined. All the body dies I have will set the shoulder back wherever you want to include collapsing the shoulder. Just take a fired case measure from the base to the shoulder datum run it through the die,(make sure it cams over), measure again. If that's not enough setback, screw your die down 1/4 turn and try again until you get what you want. Simple as that.</p><p>db</p></blockquote><p></p>
[QUOTE="dbhostler, post: 66602, member: 799"] You shouldn't have to have any component machined. All the body dies I have will set the shoulder back wherever you want to include collapsing the shoulder. Just take a fired case measure from the base to the shoulder datum run it through the die,(make sure it cams over), measure again. If that's not enough setback, screw your die down 1/4 turn and try again until you get what you want. Simple as that. db [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Dies not sizing enough?
Top