Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
CZ 550 Scope Mounting vertical problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="benchracer" data-source="post: 895145" data-attributes="member: 22069"><p>The point of impact issue is occurring during load development, so I am not sure changing ammunition is the answer. However, bedding the scope in the rings sounds like that would be a viable fix. If that solution were employed, I am guessing that the rings would need to be lapped and that bedding of the front and rear ring would be required to accommodate the new angle of the scope tube. Is that right?</p><p> </p><p> I will probably consult a good smith to do the work, but now I at least can hold an intelligent conversation regarding the fix for the problem. Thank you for your insight.</p></blockquote><p></p>
[QUOTE="benchracer, post: 895145, member: 22069"] The point of impact issue is occurring during load development, so I am not sure changing ammunition is the answer. However, bedding the scope in the rings sounds like that would be a viable fix. If that solution were employed, I am guessing that the rings would need to be lapped and that bedding of the front and rear ring would be required to accommodate the new angle of the scope tube. Is that right? I will probably consult a good smith to do the work, but now I at least can hold an intelligent conversation regarding the fix for the problem. Thank you for your insight. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
CZ 550 Scope Mounting vertical problems
Top