Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Creating tight neck brass for a factory chamber
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Alaskan338Lapua" data-source="post: 287744" data-attributes="member: 18159"><p>You hit the nail on the head, all those little things add up. Alright then, we can craft a whole slew of short action cases from 30-06 brass, but moving on to bigger and better things, how about 300 win mag off of 300 H&H. If I remember correctley they both have the same head diameter but correct me if I am wrong. In the past I have tried to make 300 WSM of of some of my non-reloading friends 300 RUM brass but that diddn't turn out too well and the case capacity was severely reduced.</p></blockquote><p></p>
[QUOTE="Alaskan338Lapua, post: 287744, member: 18159"] You hit the nail on the head, all those little things add up. Alright then, we can craft a whole slew of short action cases from 30-06 brass, but moving on to bigger and better things, how about 300 win mag off of 300 H&H. If I remember correctley they both have the same head diameter but correct me if I am wrong. In the past I have tried to make 300 WSM of of some of my non-reloading friends 300 RUM brass but that diddn't turn out too well and the case capacity was severely reduced. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Creating tight neck brass for a factory chamber
Top