Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Cleaning re-sizing dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Wado" data-source="post: 1174953" data-attributes="member: 42926"><p>Never use Scotch Brite pads to clean them, they can scratch. I was converting .223 to .300 Blackout and was running brass that had been acid cleaned but not polished and clogged the vent hole in my die with junk so that's something to watch for. I started de-burring and polishing after sawing the brass and that eliminated the problem. I store my dies in a climate controlled room with a dehumidifier in the cabinet so they don't rust also. All of my Wilson tools get wiped down with Rusteprufe before I put them away. Part of living on the Gulf Coast.</p></blockquote><p></p>
[QUOTE="Wado, post: 1174953, member: 42926"] Never use Scotch Brite pads to clean them, they can scratch. I was converting .223 to .300 Blackout and was running brass that had been acid cleaned but not polished and clogged the vent hole in my die with junk so that's something to watch for. I started de-burring and polishing after sawing the brass and that eliminated the problem. I store my dies in a climate controlled room with a dehumidifier in the cabinet so they don't rust also. All of my Wilson tools get wiped down with Rusteprufe before I put them away. Part of living on the Gulf Coast. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Cleaning re-sizing dies
Top