Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Chamber? Bolt face? or Dies?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="4ked Horn" data-source="post: 70459" data-attributes="member: 11"><p>Thanks for your thoughtful response. I have, at this point, a gun that shoots better than I do so I'm not looking to really get a ton more accuracy. If anything I would bee looking to save on brass and maybe get some more velocity. With what you said though I'm sure I could buy quite a bit of brass and be content with my velocities for the money saved not reworking a factory BBL.</p><p></p><p>So thats what I'll do. I'll save up for the better dies and go from there.</p><p></p><p>One last question though. And it may be a quasi-stupid question. Since Al and I are essentially fire forming our brass to a fat chamber, and will soon be neck sizing, should we rework our max loads for the new case capacity to seek another "accuracy node"? Or is the slight expansion to a SAMMI spec chamber of little consequence in getting more useable velocity?</p></blockquote><p></p>
[QUOTE="4ked Horn, post: 70459, member: 11"] Thanks for your thoughtful response. I have, at this point, a gun that shoots better than I do so I'm not looking to really get a ton more accuracy. If anything I would bee looking to save on brass and maybe get some more velocity. With what you said though I'm sure I could buy quite a bit of brass and be content with my velocities for the money saved not reworking a factory BBL. So thats what I'll do. I'll save up for the better dies and go from there. One last question though. And it may be a quasi-stupid question. Since Al and I are essentially fire forming our brass to a fat chamber, and will soon be neck sizing, should we rework our max loads for the new case capacity to seek another "accuracy node"? Or is the slight expansion to a SAMMI spec chamber of little consequence in getting more useable velocity? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Chamber? Bolt face? or Dies?
Top