Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Cerrosafe --how to use?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 600624" data-attributes="member: 2736"><p>Clean the chamber, Plug the barrel with an earplug just past the free bore into the rifling</p><p>about a 1/4 ".</p><p></p><p>Then warm the barrel up just a little with a hair drier (warm to the touch not hot).</p><p></p><p>Place the barrel vertical and pore the Cerrosafe in the center of the chamber being careful</p><p>not to fill it beyond the top of the barrel (If it is over filed it will hang up on the inside of </p><p>the action).</p><p></p><p>In a few minutes, using a bore jag smaller than the cleaning rod, tap the Cerrosafe casting </p><p>out of the chamber, (Be sure to use a rod guide that goes in the muzzle to prevent any damage </p><p>to the crown). place the back end of the action on a piece of carpet to keep from damaging </p><p>the casting of your chamber.</p><p></p><p>You should not have any problems unless there is something very wrong with the chamber.</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 600624, member: 2736"] Clean the chamber, Plug the barrel with an earplug just past the free bore into the rifling about a 1/4 ". Then warm the barrel up just a little with a hair drier (warm to the touch not hot). Place the barrel vertical and pore the Cerrosafe in the center of the chamber being careful not to fill it beyond the top of the barrel (If it is over filed it will hang up on the inside of the action). In a few minutes, using a bore jag smaller than the cleaning rod, tap the Cerrosafe casting out of the chamber, (Be sure to use a rod guide that goes in the muzzle to prevent any damage to the crown). place the back end of the action on a piece of carpet to keep from damaging the casting of your chamber. You should not have any problems unless there is something very wrong with the chamber. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Cerrosafe --how to use?
Top