Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case sizing problems?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ropeNshoot" data-source="post: 1155142" data-attributes="member: 70717"><p>So I got out some once fired WW and Rem cases and reset my FL sizing die according to the RCBS instructions. Adjusted to those specs I get 2.209" from case head to shoulder. I cannot make them any shorter because the press won't cam over (the die is too low). </p><p></p><p>I can't get anywhere near the 2.196" that is specified in the manual or measured on good factory rounds. I've got the right shellholder and the dies used to produce rounds that fit/functioned fine. </p><p></p><p>What's up?</p></blockquote><p></p>
[QUOTE="ropeNshoot, post: 1155142, member: 70717"] So I got out some once fired WW and Rem cases and reset my FL sizing die according to the RCBS instructions. Adjusted to those specs I get 2.209" from case head to shoulder. I cannot make them any shorter because the press won't cam over (the die is too low). I can't get anywhere near the 2.196" that is specified in the manual or measured on good factory rounds. I've got the right shellholder and the dies used to produce rounds that fit/functioned fine. What's up? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case sizing problems?
Top