Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case neck thickness?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="KQguy" data-source="post: 268890" data-attributes="member: 9704"><p>Is there a standard size for case neck thickness?I have two different lot #'s of winchester brass for a 7mmWSM.One batch measures .013"-.014",the other .015"-.016".I neck turned the first batch,and just cleaned them up to .013"(just scraping off the high spots).Before I turn down the other batch to .013",to match the first batch,I just wanted to make sure I am not making a mistake.Normally I only like to just cut about 70% off,but in this case I will most likely be cutting 100%.Is .013" a good size,even though they are currently .015-.016" now?</p></blockquote><p></p>
[QUOTE="KQguy, post: 268890, member: 9704"] Is there a standard size for case neck thickness?I have two different lot #'s of winchester brass for a 7mmWSM.One batch measures .013"-.014",the other .015"-.016".I neck turned the first batch,and just cleaned them up to .013"(just scraping off the high spots).Before I turn down the other batch to .013",to match the first batch,I just wanted to make sure I am not making a mistake.Normally I only like to just cut about 70% off,but in this case I will most likely be cutting 100%.Is .013" a good size,even though they are currently .015-.016" now? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case neck thickness?
Top