Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Can a Case be too Short?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MagnumManiac" data-source="post: 1569054" data-attributes="member: 10755"><p>I don't trim until ALL the cases in a batch require it and I measure to the end of ALL my chambers. </p><p>I've got reamers here, 3x 'A191' reamers, and their prints, but on one the reamer doesn't match the print.</p><p>The actual length is shorter than stated.</p><p>I run the brass at .010" shorter than the chamber end, it gets trimmed at .005" short of the end.</p><p></p><p>Cheers.</p></blockquote><p></p>
[QUOTE="MagnumManiac, post: 1569054, member: 10755"] I don’t trim until ALL the cases in a batch require it and I measure to the end of ALL my chambers. I’ve got reamers here, 3x ‘A191’ reamers, and their prints, but on one the reamer doesn’t match the print. The actual length is shorter than stated. I run the brass at .010” shorter than the chamber end, it gets trimmed at .005” short of the end. Cheers. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Can a Case be too Short?
Top