Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bumping shoulder neck sizing neck turning
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="desertbull" data-source="post: 1004527" data-attributes="member: 25995"><p>Redding has a full length bushing die that will bump the shoulder and size the neck with a bushing, letting you control neck tension very precisely. The same die is converted to a body die by leaving out the bushing. It has an expander but it can be removed and still punch out the primer.</p><p></p><p>you could also get a Forster and have it honed by factory to get precise neck tension. I think most die MFG offer this but I know Forster does for sure.</p><p></p><p>If you are going to turn the necks, you should probably just take off as little as possible to true them up. </p><p></p><p>Personally, I would spend the money on bullets, primers and powder until you get a solid load developed using basic reloading steps before diving into the advanced stuff that might not make a difference in your groups until you start getting to 1,000 or more. </p><p></p><p>You can make VERY solid reloads with a basic die set.</p></blockquote><p></p>
[QUOTE="desertbull, post: 1004527, member: 25995"] Redding has a full length bushing die that will bump the shoulder and size the neck with a bushing, letting you control neck tension very precisely. The same die is converted to a body die by leaving out the bushing. It has an expander but it can be removed and still punch out the primer. you could also get a Forster and have it honed by factory to get precise neck tension. I think most die MFG offer this but I know Forster does for sure. If you are going to turn the necks, you should probably just take off as little as possible to true them up. Personally, I would spend the money on bullets, primers and powder until you get a solid load developed using basic reloading steps before diving into the advanced stuff that might not make a difference in your groups until you start getting to 1,000 or more. You can make VERY solid reloads with a basic die set. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bumping shoulder neck sizing neck turning
Top