Brass Prep Advise Please

[texas270]

I have about 50 cases, each fired one time from my 270 win which were used for developing a new load. Unfortunately I decapped/resized them at different times with slightly differing settings.

The shoulder bumps vary by 0.005" and the length of the neck crimps vary by as much as 0.05".

should I reload and use them for shooting/hunting as they are, or should I run them through the die/ram again to uniform them?

Would they be accurate as they are?

Would running them through the die again be overly hard on the brass?

thanks much for feedback!

 

[Walktallshy]

As long as you haven't created any headspace issues with your sizing cut excessively short necks, I would run them as foulers and regular old hunting loads. If I am reading you right, factory fodder can have similar variation.

 

[varmintH8R]

+1. You should be Good to go.

 

[texas270]

Thanks to both of you!