bolt wont close???

[Reloader222]

However it seems i used a little to much lube on my brass because some of my shoulders are rippled. Thanks for all your help.

Try to use die wax from Redding. You only apply in a thin layer for the first 2 cases and thereafter you only apply on every 2nd case. See what works best.

 

[OKIE2]

Well i purchased a FL sizing die and a Wilson case length gauge. Set up die per included instructions, resized some brass, measured with gauge trimmed, as necessary and they seem to be cycling through rifle fine now. However it seems i used a little to much lube on my brass because some of my shoulders are rippled. Thanks for all your help.

buy some sizing wax you will never have that problem again.

 

[kc0pph]

I use a case lube pad from RCBS and the RCBS water soluble lube. Works great. Just dot the pad with lube, run your finger over it after you use it and next time you use it, it will be ready and perfect. Also dont over roll your cases, or put too much pressure on them. A light coating will do a great job.