Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Best Practices for New Brass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="LaHunter" data-source="post: 2336347" data-attributes="member: 54963"><p>1st, buy a set of the Redding Comp Shell Holders. Use the .010 shell holder while sizing all your brass. This will allow minimal shoulder bump. If this brass eventually gets tight in your chamber, after a few firings, switch to the .008 shell holder. New, once fired brass will be a little slower than fired / sized brass, but you can still find a very accurate load for new brass that should still be good with this same brass once fired. I do not mix head stamps of brass</p><p>Good luck</p></blockquote><p></p>
[QUOTE="LaHunter, post: 2336347, member: 54963"] 1st, buy a set of the Redding Comp Shell Holders. Use the .010 shell holder while sizing all your brass. This will allow minimal shoulder bump. If this brass eventually gets tight in your chamber, after a few firings, switch to the .008 shell holder. New, once fired brass will be a little slower than fired / sized brass, but you can still find a very accurate load for new brass that should still be good with this same brass once fired. I do not mix head stamps of brass Good luck [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Best Practices for New Brass
Top