Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding gone BAD
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ejg" data-source="post: 287456" data-attributes="member: 12381"><p>I was always wondering why.... why.... different rules apply to gunsmithing??? Aerospace moulding , boat moulding and many more use professional release agents especially for epoxy. but!!! on the net we read this all does not apply to gunsmithing, we get told to use butter or shoe polish or hell knows maybe even spit..</p><p> </p><p>I have used shoe polish in the passt and one can get away with it but there are much safer options. </p><p>A two part system works very reliable. Release wax that is trimmed to work together with PVA (I think polyvinyl alcohol). Wax and then paint layer of PVA over which creates a film that will disolve later with water.</p><p> </p><p>If you have not heat cured yet, you might have a chance if you heat up to 80 deg C and hopefully the epoxy might get a bit softer, then try to remove.</p><p> </p><p>edi</p></blockquote><p></p>
[QUOTE="ejg, post: 287456, member: 12381"] I was always wondering why.... why.... different rules apply to gunsmithing??? Aerospace moulding , boat moulding and many more use professional release agents especially for epoxy. but!!! on the net we read this all does not apply to gunsmithing, we get told to use butter or shoe polish or hell knows maybe even spit.. I have used shoe polish in the passt and one can get away with it but there are much safer options. A two part system works very reliable. Release wax that is trimmed to work together with PVA (I think polyvinyl alcohol). Wax and then paint layer of PVA over which creates a film that will disolve later with water. If you have not heat cured yet, you might have a chance if you heat up to 80 deg C and hopefully the epoxy might get a bit softer, then try to remove. edi [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding gone BAD
Top