Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding a stock question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Firearrow" data-source="post: 1241755" data-attributes="member: 18733"><p>Ok read that article and I see now that the .035 gap they referred to allows the bedding compound to be uniform instead of bedding compound then pillars and so forth. But if the pillars are installed at the factory would I just relieve the area around the pillars and just allow the bedding compound to take a natural form around the pillars and under the action with no compound between the action and pillars? If this makes any since?</p></blockquote><p></p>
[QUOTE="Firearrow, post: 1241755, member: 18733"] Ok read that article and I see now that the .035 gap they referred to allows the bedding compound to be uniform instead of bedding compound then pillars and so forth. But if the pillars are installed at the factory would I just relieve the area around the pillars and just allow the bedding compound to take a natural form around the pillars and under the action with no compound between the action and pillars? If this makes any since? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding a stock question
Top