Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bed both ends of rail or just one end???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bluedog69" data-source="post: 2251956" data-attributes="member: 118823"><p>Well here are my first attempts. I bedded front and back. Used all four screws to barely squeeze glue out. Seeing that they seemed perfect to start with…. No rocking or gaps that I could see I imagine these should be fine. The one with the bad looking spots was either very thin there or need another hour to cure. Anyway. Bout gotta be better than not doing it. </p><p>[ATTACH=full]288416[/ATTACH][ATTACH=full]288417[/ATTACH]They came very clean on the edges too. Doubt you will be able to see at all unless you are looking very hard to see it. </p><p>Thanks for all the tips!!!</p></blockquote><p></p>
[QUOTE="bluedog69, post: 2251956, member: 118823"] Well here are my first attempts. I bedded front and back. Used all four screws to barely squeeze glue out. Seeing that they seemed perfect to start with…. No rocking or gaps that I could see I imagine these should be fine. The one with the bad looking spots was either very thin there or need another hour to cure. Anyway. Bout gotta be better than not doing it. [ATTACH type="full"]288416[/ATTACH][ATTACH type="full"]288417[/ATTACH]They came very clean on the edges too. Doubt you will be able to see at all unless you are looking very hard to see it. Thanks for all the tips!!! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bed both ends of rail or just one end???
Top