Baer Custom Stock Rem. 700 SA

Discussion in 'Gun Parts - Stocks, Barrels, Actions, etc.' started by lgordee, May 29, 2013.

Thread Status:
Not open for further replies.
  1. lgordee

    lgordee Well-Known Member

    Messages:
    154
    Joined:
    Jul 10, 2012
    I have for sale a Baer Custom Rifle Stock for a Remington 700 RH SA. If you are looking for a pretty and unique stock, this fills the bill. This stock is an ambidextrous design for a Right Hand Bolt, but can be fired either left or right side. In other words, there are cheek rests on both sides of the stock. This stock has a BDL style inlet. I installed a sling stud insert in the forearm so that it can be used with a bipod. The forearm is a 3" wide benchrest style and will work well on a rest. The pillars are installed and the stock is ready to be bedded to your action. I finished the stock with high quality, non yellowing, automotive clear coat. The butt plate is aluminum. The barrel channel is cut for heavy barrels. I layed a 1.250" taper down to .980" at the muzzle inside the channel and it fits nice. Price is $485.00 shipped tyd in the lower 48. I can furnish a new bottom metal with spring and 308 floor plate at an additional $100.00. If you would like me to Devcon bed it to your action, we can arrange that also. I cannot get the photos to upload. PM me and I will email them to you. Thanks for reading!
     
  2. lgordee

    lgordee Well-Known Member

    Messages:
    154
    Joined:
    Jul 10, 2012

  3. Hunter2678

    Hunter2678 Well-Known Member

    Messages:
    601
    Joined:
    May 2, 2012
    Very nice stock..wish it was a non mag well single shot config.
     
  4. lgordee

    lgordee Well-Known Member

    Messages:
    154
    Joined:
    Jul 10, 2012
    Thanks for complimenting. I have a 6BR with a single shot follower in place that I run a BDL bottom metal on with no spring or box. so if that would be of interest, let me know. :)
     
  5. Hunter2678

    Hunter2678 Well-Known Member

    Messages:
    601
    Joined:
    May 2, 2012
    Appreciate the offer but my action is a Stiller single shot P1000 1.550''. I need a non magwell stock or ADL (blind mag) at worst.
     
Thread Status:
Not open for further replies.