Attention 7mm Allen Mag Owners!

Discussion in 'Reloading Equipment and Components' started by jedlowe, Jun 25, 2010.

  1. jedlowe

    jedlowe Well-Known Member

    Messages:
    535
    Joined:
    Feb 15, 2005
    I have a box of 100 338 Lapua brass that was necked down and annealed by Kirby to 7mm. It is ready to be formed up into 7mm Allen Mag brass. I will never get to this last box as I had Kirby neck down and anneal a whole pile of 338 Lapua brass for me. I am looking to get $250 for this which is what the brass would cost you not factoring in what I paid Kirby to neck down and anneal this stuff. I will also trade straight across for 100 new 338 Lapua brass as I need to feed a new 338 AX Raptor that is in the works.
     
  2. jedlowe

    jedlowe Well-Known Member

    Messages:
    535
    Joined:
    Feb 15, 2005
    Bump up. This will save a lot of annealing and necking down time for the same price as 338 Lapua brass. You also know it was done right since Kirby did it.
     

  3. jedlowe

    jedlowe Well-Known Member

    Messages:
    535
    Joined:
    Feb 15, 2005
    Bump up!
     
  4. wyo7

    wyo7 Well-Known Member

    Messages:
    56
    Joined:
    May 3, 2009
    PM sent.
     
  5. jeffwhip

    jeffwhip Well-Known Member

    Messages:
    107
    Joined:
    Dec 31, 2009
    PM Sent.
     
  6. Norseman

    Norseman Well-Known Member

    Messages:
    81
    Joined:
    Jun 25, 2003
    PM sent as well!!!!!!!!!!!!!!!!!!!
     
  7. jedlowe

    jedlowe Well-Known Member

    Messages:
    535
    Joined:
    Feb 15, 2005
    Sorry for not posting sooner. This brass is sold.