Any loading tips for 6.5-284??

Discussion in 'Rifles, Bullets, Barrels & Ballistics' started by PrimeTime, Mar 15, 2002.

  1. PrimeTime

    PrimeTime Well-Known Member

    Messages:
    256
    Joined:
    May 9, 2001
    I picked up my gun and will start out using 284 Winchester brass. I ordered a Redding full length die and will run the brass thru that first to neck it down. Then, I will run the K&M expander mandrel thru all of them and turn necks. Finally, a Redding neck bushing die will be used, bushing size is .002 under what I want the loaded round to be. Naturally, all cases have been match prepped. Does that sound like the best way to go about this or is there a better method?
     
  2. ShootLong

    ShootLong Member

    Messages:
    21
    Joined:
    Mar 7, 2002
    unless you have a tite neck chamber you should fireform the brass before you turn the necks.